Allegro PCB Designer TUTORIAL

orcad allegro tutorial measure distance

Hey guys!I hope you all are good, this is fifth tutorial in the series of the “Introduction to Allegro PCB Designer”. In the previous tutorials I have discussed about the basic commands used frequently while developing the layout of the printed circuit board at beginners’ level; we have learned about the “Add Connect”, “Slide”, “Hilight”,…

Allegro Use Add Connect Tool

Hey guys!I hope you all are good, in the previous tutorial I have discussed the brief introduction of the Allegro PCB designer software and few commands used for routing, I have discussed in detail the “Add Connect” command, in this tutorial I will further explain about how to adjust the bent angle and width of…