Blinking project interfacing ESP32 simulation in proteus

Blinking project interfacing ESP32 simulation in proteus

In this article we will learn how to interface blinking project with ESP32 in proteus.
In the last post we will learn how to interface arduino and I2C display with piezoelectric sensor in proteus. You can visit our website,
I hope you appreciate my work, let’s discuss about today’s project.

Components which we use in this project are listed below:

  1. ESP32
  2. Resistor 10k
  3. LED
  4. Jumper wires

Diagram of this project is below 

Blinking project interfacing ESP32 simulation in proteus
Blinking project interfacing ESP32 simulation in proteus

Construction of Blinking project interfacing ESP32 simulation in proteus

  • Connect the Sk pin of ESP with one side of resistor
  • Connect the other side of resistor with the +ve side of LED
  • Connect the –ve side of LED with the GND

Working of Blinking project interfacing ESP32 simulation in proteus

The ESP32 is a popular microcontroller and system-on-a-chip (SoC) that is commonly used in a wide range of IoT applications.  The ESP32 is an advanced successor to the ESP8266 and comes with a wide range of features and capabilities. One of the key features of the ESP32 is its built-in Wi-Fi and Bluetooth capabilities. It supports both Wi-Fi and Bluetooth. This makes it ideal for IoT applications that require wireless communication

Applications of Blinking project interfacing ESP32 simulation in proteus

  1. IoT Devices
  2. Wearable Devices
  3. Home Automation
  4. Environmental Monitoring
  5. Robotics

Advantages of Blinking project interfacing ESP32 simulation in proteus

  1. Dual-Core Processor
  2. Wireless Connectivity
  3. Low Power Consumption
  4. Security Features

Program code of this project is below:

void setup() {

// initialize digital pin LED_BUILTIN as an output.

pinMode(LED_BUILTIN, OUTPUT);

}

 

// the loop function runs over and over again forever

void loop() {

digitalWrite(LED_BUILTIN, HIGH);  // turn the LED on (HIGH is the voltage level)

delay(1000);                      // wait for a second

digitalWrite(LED_BUILTIN, LOW);   // turn the LED off by making the voltage LOW

delay(1000);                      // wait for a second

}

admin