Light intensity LDR sensor in proteus -

Light intensity LDR sensor in proteus

In this article we will learn how to Interface Light Intensity and LDR sensors in proteus.
In the last post we will learn how to make Half wave Rectification in proteus. You can visit our website,
I hope you appreciate my work, let’s discuss about today’s project.

Components which we use in this project are listed below:

LDR sensor
Intensity meter
Resistor 10k
Resistor variable 10k
IC LM324
LED
Resistor 100k
Jumper wires

Diagram of this project is below:

Construction of Light intensity LDR sensor in proteus

Connect the one side of LDR with the GND
Connect the other side of LDR with the one side of resistor 10k
Connect the other side of R1 with the +ve
Connect the –ve terminal of IC LM324 with the junction of LDR and R1
Connect the one side of R2 with the ammeter point of RV1
Connect the other side of R2 with the GND
Connect the collector point of RV1 with the +ve
Connect the signal point of RV1 with the +ve pin of IC LM324 through the junction of R2 and RV1
Connect the –ve side of IC with the GND
Connect the +ve side of IC with the +ve
Connect the signal pin of IC with the +ve side of LED
Connect the –ve side of LED with the one side of R3 100k
Connect the other side of R3 with the GND

Working of Light intensity LDR sensor in proteus

(LDR) A Light Dependent Resistor also known as a photo resistor is a type of electronic component that exhibits a change in its electrical resistance when exposed to varying levels of light intensity. LDRs are widely used in various applications, such as automatic lighting control, streetlights, photography, and more.

Applications of Light intensity LDR sensor in proteus

Light Control Systems
Photography
Solar Panels
Security Systems
Greenhouse Automation

Advantages of Light intensity LDR sensor in proteus

Cost-Effective
Simple Construction
Wide Range of Applications
Low Power Consumption
Reliability