5v DC power supply in proteus simulation

In this article we will learn how to make 5V DC power supply in proteus.
In the last post we will learn how to interface IC555 with capacitive touch sensor in proteus. You can visit our website,
I hope you appreciate my work, let’s discuss about today’s project.

Components which we use in this project are listed below:

Regulator (7805)
Battery 12v
Capacitor (1000uf)
Capacitor (100uf)
Resistor (100R)
LED
Jumper wires

Diagram of this project is below:

5v DC power supply in proteus simulation

Construction of 5v DC power supply in proteus simulation

Connect one side of 12V battery with the Vin pin of Regulator (7805) through the +ve pins of capacitor (1000uf) and capacitor (100uf)
Connect the Vo pin of regulator with the +ve side of C4 through the one side of Resistor (100R) and C3
Connect the other side of resistor with the +ve side of LED
Connect the –ve side of C4 with the GND pin of Regulator through the –ve side of LED and C3
Connect the other side of 12v battery with the GND point of regulator through the –ve sides of capacitor (1000uf) and (100uf)

Working of 5v DC power supply in proteus simulation

A 5V DC (Direct Current) power supply is a device or circuit that provides a constant voltage of 5 volts to power electronic components, devices, or circuits. These power supplies are commonly used to power a wide range of electronic devices such as microcontrollers, sensors, LEDs, and various digital and analog circuits.