LM2595 switching 1A 3V regulator in proteus simulation -

LM2595 switching 1A 3V regulator in proteus simulation

In this article we will learn how to Interface LM2595 switching 1A 3v regulator in proteus simulation.
In the last post we will learn how to Interface LM1086 series with 5v regulator in proteus. You can visit our website,
I hope you appreciate my work, let’s discuss about today’s project.

Components which we use in this project are listed below:

Regulator (LM2595)
Capacitor (220uf)
Capacitor (330uf)
Resistor (3.3k)
Inductor (220uH)
Diod (1N5822)
Jumper wires

Diagram of this project is below:

Construction of LM2595 switching 1A 3V regulator in proteus simulation

Connect Vin pin of regulator with the +ve side of capacitor 220uf then connect them with +ve
Connect –ve side of capacitor with the GND
Connect ON tab of regulator with the GND
Connect pin 6 of regulator with GND
Connect pin 3 of regulator with the GND
Connect Out pin of regulator with one side of diod and inductor
Connect the other side of inductor with one side of capacitor 330uf and resistor
Connect FB pin of regulator with the junction of inductor and capacitor
Connect the 2^nd side of resistor with the GND
Connect the 2^nd side of capacitor 330uf with the GND
Connect the 2^nd side of diod with the GND

Working of LM2595 switching 1A 3V regulator in proteus simulation

The LM2595 is a popular voltage regulator integrated circuit (IC) that uses a switching regulator topology to efficiently step down voltage from a higher input voltage to a lower output voltage. It can handle an output current of up to 1 ampere and is commonly used in various electronic applications where voltage regulation is required.

Applications of LM2595

DC-DC Buck Converter
Power Supply
Battery Charging
Voltage Regulation
Test and Measurement Equipment

Advantages of LM2595

Wide Input Voltage Range
Low Dropout Voltage
High Efficiency
Thermal Shutdown
Simple to Use