741 Chain sample circuit in proteus simulation

741 Chain sample circuit in proteus simulation

In this article we will learn how to interface 741 Chain sample circuit in proteus simulation.
In the last post we will learn how to Interfacing 741 Noise Analysis circuit in proteus. You can visit our website,
I hope you appreciate my work, let’s discuss about today’s project.

Components which we use in this project are listed below:

1. Battery (15v)
2. IC 741
3. Resistor (RF 50000)
4. Resistor (100000)
5. Jumper wires

Diagram of this project is below:

Construction of 741 Chain sample circuit in proteus simulation

• Connect one side of 1^st battery with +ve sides of 4 ICs
• Connect signal pin of 4^th IC with +ve pin of 5^th IC
• Connect 2^nd side of 1^st battery with one side of 2^nd battery
• Connect 2^nd side of 2^nd battery with remaining 3 ICs –ve sides
• Connect one side of resistor (50000) with the junction of both batteries
• Connect 2^nd side of resistor (50,000) with pin 2 of IC 1^st
• Connect signal pin of 1^st IC with pin 3 of 2^nd IC
• Connect one side of resistor (100000) with pin 2 of IC
• Connect 2^nd side of this resistor with connection of signal pin and pin 3 of 2^nd IC
• Connect –ve pin of 1^st IC with 2^nd side of 2^nd battery
• Connect –ve side of 2^nd IC with pin 3 of 3^rd IC through pin 6 of 2^nd IC
• Connect –ve side of 2^nd IC with 2^nd side of 2^nd battery
• Connect –ve side of 3^rd IC with pin 3 of 4^th IC through pin 6 of 3^rd IC
• Connect –ve side of 3^rd IC with 2^nd side of 2^nd battery
• Connect –ve side of 4^th IC with pin 6
• Connect –ve pin of 4^th IC with 2^nd side of 2^nd battery
• Connect pin 6 of IC 4^th with pin 3 of IC 5^th
• Connect pin +ve of IC 5^th with common of all +ve of all ICs
• Connect –ve pin of IC 5^th with –ve terminal of 2^nd battery
• Connect pin 2 of 5^th IC with pin 3 of 6^th IC through pin 6
• Connect pin 2 of 6^th IC with pin 3 of 7^th IC through pin 6
• Connect pin 2 of 7^th IC with pin 6
• Then give out put

Working of 741 Chain sample circuit in proteus simulation

The 741 is a classic and widely used op-amp integrated circuit. Op-amps are versatile electronic devices that amplify the difference in voltage between two input terminals (inverting and non-inverting) and produce an output voltage based on that difference. They are used in various electronic circuits for amplification, signal conditioning, filtering, and more.

A chain circuit is not a standard term in electronics, but it might refer to a series of connected circuits or components. To provide a general idea of how a 741 op-amp might be used in such a context

Applications of 741 Chain sample circuit in proteus simulation

1. Signal Amplification
2. Filters
3. Oscillators
4. Voltage Comparators

Advantages of 741 Chain sample circuit in proteus simulation

1. Versatile
2. High Gain
3. Low Offset Voltage
4. Easy to Use