Arduino interfacing with LEDs circuit in proteus

Arduino interfacing with LEDs circuit in proteus

In this article we will learn how to Interface Arduino with LEDs circuit in proteus.
In the last post we will learn how to make Frequency counter circuit using Arduino in proteus. You can visit our website,
I hope you appreciate my work, let’s discuss about today’s project.

Components:

1. Arduino (328)
2. Resistors (330, 1k)
3. LEDs (RED, Green)
4. Push button
5. Jumper wires

Construction…

• Connect one side of 1^st resistor 330 with D8 pin of Arduino
• Connect 2^nd side of 1^st R330 with +ve side of 1^st LED
• Connect –ve side of 1^st LED with GND
• Connect one side of 2^nd resistor 330 with D9 pin of Arduino
• Connect 2^nd side of 2^nd R330 with +ve side of 2^nd LED
• Connect –ve side of 2^nd LED with GND
• Connect VCC pin of Arduino with +5V
• Connect one side of resistor with +5V
• Connect 2^nd side of resistor with one side of push button and then connect them with Reset
• Connect 2^nd side of push button with –ve side of LED and then connect them with GND
• Connect +ve side of LED with one side of resistor
• Connect 2^nd side of resistor with D13 pin of Arduino

Working…

Arduino circuit with LEDs is a great way to get started with electronics and programming. You can create various patterns and effects with LEDs using Arduino.

Applications…

1. LED Blinking
2. LED Light Show
3. LED Matrix Displays
4. Traffic Lights Simulation
5. LED Clock

Advantages…

1. Ease of Use
2. Low Cost
3. Precise Control
4. Low Power Consumption
5. Learning Platform