Arduino MPX4250AP pressure gauge circuit in proteus
Arduino MPX4250AP pressure gauge circuit in proteus
In this article we will learn how to Interface Arduino MPX4250AP pressure gauge circuit in proteus.
In the last post we will learn how to Interface Calculator using Arduino Uno in proteus simulation. You can visit our website,
I hope you appreciate my work, let’s discuss about today’s project.
Components:
- Arduino (328)
- Pressure gauge (MPX4250AP)
- Resistor
- LED
- Push button
- Jumper wires
Construction…
- Connect pin 1 of Pressure gauge with D0 pin of Arduino
- Connect pin 2 of Pressure gauge with GND pin of Arduino
- Connect pin 3 of Pressure gauge with +5V
- Connect VCC pin of Arduino with +5V
- Connect one side of resistor with +5V
- Connect 2nd side of resistor with one side of push button and then connect them with Reset
- Connect 2nd side of push button with –ve side of LED and then connect them with GND
- Connect +ve side of LED with one side of resistor
- Connect 2nd side of resistor with D13 pin of Arduino
Working…
The Arduino MPX4250AP pressure gauge circuit is a setup that allows you to measure pressure using the MPX4250AP pressure sensor and an Arduino microcontroller.
Applications…
- Weather Stations
- Industrial Automation
- Medical Devices
- Liquid Level Measurement
- Leak Detection
Advantages…
- Wide Pressure Range
- Analog Output
- Easy to Interface
- Low Noise
- Compact Size
